This Standard is applicable to any organizations that perform the following items :

a) improve robot service safety performance;

b) establish, implement, maintain, and improve a robot service safety management system;

c) assure by itself the conformity to the presented robot service safety policy;

d) demonstrate conformity with this Standard.

Requirements in this Standard may be integrated into the existing management system or work process of the organization or may be satisfied as a part of them.

Requirements in this Standard may cover and be enforced over multiple organizations, depending on the contents to be implemented for the organization and safety management.

This Standard may be applied to services using robots other than service robots and robotic devices.

NOTE It should be noted that the robot service safety management system established according to the requirements in this Standard may not be applicable as it is if the service robots and robot service system to be used, operational contents of the service, place of implementation, targeted beneficiaries of the service, etc., are different.

NOTE 1 In this Standard, the term electrical includes electrical, electronic, and programmable electronic matters (i.e. electrical equipment means electrical, electronic, and programmable electronic equipment).

NOTE 2 In the context of this Standard, the term person refers to any individual and includes those persons who are assigned and instructed by the user or his agent(s) in the installation, use, and care of the fabrication equipment in question.

The electrical equipment covered by this Standard commences at the point of connection of the supply to the electrical equipment (see 5.1), and includes proper instruction for its safe installation operation.

NOTE 3 For the requirements for the electrical supply installation in buildings, see JIS C 60364 series.

This Standard is applicable to the electrical equipment or parts of the electrical equipment that operate with nominal supply voltages not exceeding 1 000 V for alternating current (a.c.) and not exceeding 1 500 V for direct current (d.c.), and with nominal supply frequencies not exceeding 200 Hz.

For higher voltages or frequencies, special requirements may be needed.

NOTE 4 Electrical equipment within which derived voltages exceed these supply voltage limits is within the scope of this Standard.

Included are requirements for protective measures against electrical safety hazards as well as electrical interlock circuits that protect against non-electrical hazards.

However, it does not cover all the requirements that are needed or required by other standards or regulations in order to safeguard persons from hazards other than electrical hazards (e.g. chemical hazards, mechanical hazards, radiation hazards).

Each type of machine has unique requirements to be accommodated to provide adequate safety.

Additional and special requirements can apply to the electrical equipment of fabrication equipment that:

– use, process, or produce potentially explosive material;

– are used in potentially explosive and/or flammable atmospheres;

– have special risks when producing or using certain materials; are hoisting machines (which are covered by JIS B 9960-32).

This Standard does not include specifications for performance or functional characteristics of the fabrication equipment.

This Standard does not deal with the possible effects on human health that can result from emissions (for example, EMFs, noise) from the fabrication equipment.

This Standard does not specify requirements for electromagnetic compatibility (EMC).

NOTE 5 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.

IEC 60204-33: 2009 Safety of machinery-Electrical equipment of machines- Part 33: Requirements for semiconductor fabrication equipment (lDT)

In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.