Scope

This Standard sets out general installation and safety requirements for battery energy storage systems (BESSs), where the battery system is installed in a location, such as a dedicated enclosure or room, and is connected with power conversion equipment (PCE) to supply electric power to other parts of an electrical installation.
This Standard sets out the requirements from the battery system up to but not including the PCE. This Standard also applies to pre-assembled integrated battery energy storage systems, which also include PCE(s).
This Standard outlines the potential hazards that are associated with battery energy storage systems and their associated battery systems and specifies installation methods that minimize risks posed by these hazards.
This Standard is applicable for the following battery systems:
(a) Nominal voltage between 12 V d.c. and 1500 V d.c.
(b) Connected to either single or multiple PCEs.
(c) Using secondary or rechargeable cells.
(d) With a rated capacity equal to or greater than 1 kWh and no more than 200 kWh, at —
(i) C10 rating, for lead acid batteries; or
(ii) 0.1C, for lithium technologies; or
(iii) manufacturer’s specified energy capacity, for other technologies.
Where an installation includes multiple battery energy storage systems, this Standard applies to each individual battery energy storage system if —
(A) the total energy storage capacity is equal to or greater than 1 kWh; and
(B) each individual BESS is no more than 200 kWh.
This Standard does not apply to battery systems in the following electrical installation types:
(1) Premises with critical power continuity requirements (e.g. acute care hospitals, substation support and black start).
(2) Telecommunication applications.
(3) Electric vehicles.
(4) Portable equipment.
(5) Uninterruptible power systems (UPS) that are in accordance with AS 62040.1.1 and AS 62040.1.2.
(6) Transportable structures and vehicles that are in accordance with AS/NZS 3001.
NOTE 1 While this Standard applies to systems of up to 200 kWh, the general requirements of this Standard may apply to larger installations.
NOTE 2 This Standard applies for common BESS technologies, and is not specifically written to support all types of battery system installation types or for other storage technologies, e.g. super capacitors. This Standard may be able to be applied in full or in part to the different storage technologies, or the risk approach may be used to assess the hazards and determine mitigations.

Scope

This Standard specifies requirements for secondary batteries for use with stand-alone power systems.
Stand-alone power systems are those that are not connected to the power distribution system of an electricity supply authority. Stand-alone systems are supplied with power from one or a combination of the following sources: a photovoltaic array, a wind generator, a water generator or a diesel generator. This Standard specifies requirements for all types of batteries including lead-acid and nickel-cadmium and covers both vented and sealed cells. The Standard includes tests designed to verify the capacity, efficiency and life of batteries (see Appendices A to I).

Scope

This Standard specifies requirements for stabilized constant-potential battery chargers that are designed to supply direct current power from an alternating current source, while charging a float-type stationary battery, and which may simultaneously supply power to a connected direct current system load.

NOTE: Appendix A provides guidance on information to be supplied by a purchaser.