The purpose of this standard is to provide the minimum requirements for matched-die-molded, fiberglass-reinforced plastic weir plates, scum baffles, and mounting brackets.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 7<\/td>\n | Foreword I.\tIntroduction. I.A.\tBackground.\u2003The purpose of this standard is to establish the minimum quality requirements for matched-die-molded, fiberglass-reinforced thermoset resin weir plates, scum baffles, and mounting brackets for use in municipal and industrial water treatme I.B.\tHistory.\u2003In 1986, the AWWA Standards Council authorized the development of AWWA standards to describe matched-die-molded, fiberglass-reinforced, thermoset resin weir plates, scum baffles, and mounting brackets. Beginning in 1987 with preliminary, but I.C.\tAcceptance.\u2003In May 1985, the US Environmental Protection Agency (USEPA) entered into a cooperative agreement with a consortium led by NSF International (NSF) to develop voluntary third-party consensus standards and a certification program for direct <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | II.\tSpecial Issues.\u2003This standard has no applicable information for this section. III.A.\tPurchaser Options and Alternatives.\u2003The following information should be provided by the purchaser: <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | III.B.\tModification to Standard.\u2003Any modifications to the provisions, definitions, or terminology in this standard must be provided by the purchaser. IV.\tMajor Revisions.\u2003Major revisions made to the standard in this edition include the following: V.\tComments.\u2003If you have any comments or questions about this standard, please call AWWA Engineering and Technical Services at 303.794.7711, FAX at 303.795.7603, write to the department at 6666 West Quincy Avenue, Denver, CO 80235-3098, or email at standa <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | AWWA Standard SECTION 1:\u2002GENERAL Sec.\u20021.1\tScope <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | Sec.\u20021.2\tPurpose Sec.\u20021.3\tApplication SECTION 2:\u2002REFERENCES <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | SECTION 3:\u2002DEFINITIONS <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | SECTION 4:\u2002REQUIREMENTS Sec.\u20024.1\tInformation to Be Supplied by the Manufacturer Sec.\u20024.2\tMaterials <\/td>\n<\/tr>\n | ||||||
| 20<\/td>\n | Sec.\u20025.3\tInspection <\/td>\n<\/tr>\n | ||||||
| 21<\/td>\n | SECTION 6:\u2002DELIVERY Sec.\u20026.1\tMarking Sec.\u20026.2\tPacking and Shipping Sec.\u20026.3\tAffidavit of Compliance <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" AWWA F102-19 Matched-Die Molded, Fiberglass-Reinforced Plastic Weir Plates, Scum Baffles, and Mounting Brackets<\/b><\/p>\n |