{"id":95776,"date":"2024-10-18T10:18:27","date_gmt":"2024-10-18T10:18:27","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/astm-d3381-4\/"},"modified":"2024-10-24T20:58:09","modified_gmt":"2024-10-24T20:58:09","slug":"astm-d3381-4","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/astm\/astm-d3381-4\/","title":{"rendered":"ASTM-D3381"},"content":{"rendered":"
\n Abstract <\/b><\/p>\n

This specification covers three sets of physical requirement limits for asphalt cements graded by viscosity at a specified temperature for use in pavement construction. The purchaser shall indicate the applicable table of limits. The cements shall be prepared from crude petroleum by suitable methods, and if needed, volume corrections should be made as well. The properties for which the materials shall be tested on and should conform to are water content, viscosity, penetration, Cleveland open cup flash point, solubility in trichloroethylene, ductility, and behavior during thin-film oven and rolling thin-film oven tests on residue.<\/p>\n

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. <\/i> <\/font><\/p>\n

1. Scope <\/b><\/p>\n

\n

1.1 This specification covers asphalt cements graded by viscosity at 60\u00b0C [140\u00b0F] for use in pavement construction. Three sets of limits are offered in this specification. The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1<\/span> shall apply. For asphalt cements graded by penetration at 25\u00b0C [77\u00b0F]. See Specification D946<\/span> . If needed, volume corrections for asphalt cements should be made according to Practice D4311<\/span> .<\/p>\n

\n
\n TABLE 1 Requirements for Asphalt Cement, Viscosity Graded at 60\u00b0C [140\u00b0F] <\/b>\n <\/div>\n
Note 1 <\/span> \u2014 Grading based on original asphalt. <\/span>\n <\/div>\n
A <\/i> <\/sup> \u2009If ductility is less than 100, material will be accepted if ductility at 15\u00b0C [60\u00b0F] is 100 minimum at a pull rate of 5 cm\/min.\n <\/div>\n<\/p><\/div>\n<\/p><\/div>\n
\n

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.<\/p>\n<\/p><\/div>\n

2. Referenced Documents <\/b> (purchase separately) <\/i> The documents listed below are referenced within the subject standard but are not provided as part of the standard.<\/span><\/p>\n

ASTM Standards <\/b><\/p>\n

<\/p>\n

D5<\/span> Test Method for Penetration of Bituminous Materials<\/p>\n

<\/p>\n

D36<\/span> Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)<\/p>\n

<\/p>\n

D70<\/span> Test Method for Density of Semi-Solid Bituminous Materials (Pycnometer Method)<\/p>\n

<\/p>\n

D92<\/span> Test Method for Flash and Fire Points by Cleveland Open Cup Tester<\/p>\n

<\/p>\n

D95<\/span> Test Method for Water in Petroleum Products and Bituminous Materials by Distillation<\/p>\n

<\/p>\n

D113<\/span> Test Method for Ductility of Bituminous Materials<\/p>\n

<\/p>\n

D140<\/span> Practice for Sampling Bituminous Materials<\/p>\n

<\/p>\n

D946<\/span> Specification for Penetration-Graded Asphalt Cement for Use in Pavement Construction<\/p>\n

<\/p>\n

D1754<\/span> Test Method for Effects of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)<\/p>\n

<\/p>\n

D2042<\/span> Test Method for Solubility of Asphalt Materials in Trichloroethylene<\/p>\n

<\/p>\n

D2170<\/span> Test Method for Kinematic Viscosity of Asphalts (Bitumens)<\/p>\n

<\/p>\n

D2171<\/span> Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer<\/p>\n

<\/p>\n

D2872<\/span> Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)<\/p>\n

<\/p>\n

D4311<\/span> Practice for Determining Asphalt Volume Correction to a Base Temperature<\/p>\n

Keywords <\/b><\/p>\n

asphalt cement; bitumen; pavement; viscosity;<\/p>\n

ICS Code <\/b><\/p>\n

ICS Number Code 93.080.20 (Road construction materials)<\/p>\n

DOI: <\/b> 10.1520\/D3381_D3381M-12 ASTM International is a member of CrossRef. <\/p>\n

\n

ASTM D3381 \/ D3381M (Road Standards and Paving Standards)<\/h2>\n<\/p><\/div>\n

Citing ASTM Standards<\/span><\/p>\n

[Back to Top]<\/span><\/p>\n<\/div>\n","protected":false},"excerpt":{"rendered":"

D3381\/D3381M-12 Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction (Redline)<\/b><\/p>\n\n\n\n\n
Published By<\/td>\nPublication Date<\/td>\nNumber of Pages<\/td>\n<\/tr>\n
ASTM<\/b><\/a><\/td>\n2012<\/td>\n3<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n","protected":false},"featured_media":95777,"template":"","meta":{"rank_math_lock_modified_date":false,"ep_exclude_from_search":false},"product_cat":[1301,2637],"product_tag":[],"class_list":{"0":"post-95776","1":"product","2":"type-product","3":"status-publish","4":"has-post-thumbnail","6":"product_cat-93-080-20","7":"product_cat-astm","9":"first","10":"instock","11":"sold-individually","12":"shipping-taxable","13":"purchasable","14":"product-type-simple"},"_links":{"self":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product\/95776","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/types\/product"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media\/95777"}],"wp:attachment":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media?parent=95776"}],"wp:term":[{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_cat?post=95776"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_tag?post=95776"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}