ASTM-D1896/D1896M:2017 Edition
$29.79
D1896/D1896M-10(2017) Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds
| Published By | Publication Date | Number of Pages |
| ASTM | 2017 | 4 |
ASTM D1896/D1896M-10-Reapproved2017
Active Standard: Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds
ASTM D1896/D1896M
Scope
1.1 This practice covers a general procedure for the transfer molding of mechanical and electrical test specimens of thermosetting molding materials.
Note 1: The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting intermediate viscosity non-Newtonian flow.
1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system are not always exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems can result in nonconformance with this practice.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2: There is no known ISO equivalent to this standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
test specimens; thermosetting compounds; transfer-molding;
ICS Code
ICS Number Code 83.140.99 (Other rubber and plastic products)
DOI: 10.1520/D1896_D1896M-10R17
