ASTM-E515:2011 Edition

ASTM E515

Scope

1.1 This practice covers procedures for detecting or locating leaks, or both, by bubble emission techniques. A quantitative measure is not practical. The normal limit of sensitivity for this test method is 4.5 × 10⁻¹⁰ mol/s (1 × 10⁻⁵ Std cm³/s).

1.2 Two techniques are described:

1.2.1 Immersion technique, and

1.2.2 Liquid application technique.

Note 1—Additional information is available in ASME Boiler and Pressure Vessel Code, Section V, Article 10-Leak Testing, and Guide E479.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

bubble leak testing; film solution leak test; immersion leak test; leak testing; vacuum box leak testing; Bubble test; Contamination; Film solution leak test; Immersion leak test; Leak testing; Leak testing–gas; Pressure testing–leaks; Vacuum box leak testing

ICS Code

ICS Number Code 19.100 (Non-destructive testing)

DOI: 10.1520/E0515-11