1.1 This specification covers corrugated aluminum pipe intended for use for storm water drainage, underdrains, the construction of culverts, and similar uses. Pipe covered by this specification is not normally used for the conveyance of sanitary or industrial wastes.<\/p>\n
1.2 This specification does not include requirements for bedding, backfill, or the relationship between earth-cover load and sheet thickness of the pipe. Experience has shown that the successful performance of this product depends upon the proper selection of sheet thickness, type of bedding and backfill, controlled manufacture in the plant, and care in the installation. The purchaser must correlate the above factors and also the corrosion and abrasion requirements of the field installation with the sheet thickness. The structural design of corrugated aluminum pipe and the proper installation procedures are given in Practices B 790\/B 790M and B 788\/B 788M, respectively. A procedure for using life-cycle cost analysis techniques to evaluate alternative drainage system designs using corrugated metal pipe is given in Practice A 930.<\/p>\n
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.<\/p>\n
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 1<\/td>\n | Scope Referenced Documents <\/td>\n<\/tr>\n | ||||||
| 2<\/td>\n | Terminology Classification Ordering Information Materials <\/td>\n<\/tr>\n | ||||||
| 3<\/td>\n | Fabrication TABLE 1 <\/td>\n<\/tr>\n | ||||||
| 4<\/td>\n | TABLE 2 FIG. 1 TABLE 3 TABLE 4 <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Pipe Requirements TABLE 5 <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | TABLE 6 TABLE 7 TABLE 8 TABLE 9 TABLE 10 TABLE 11 <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Coupling Bands FIG. 2 TABLE 12 <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | TABLE 13 TABLE 14 <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | Workmanship Inspection Rejection Certification Product Marking Keywords <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" B745\/B745M-97(2005) Standard Specification for Corrugated Aluminum Pipe for Sewers and Drains<\/b><\/p>\n |