Shopping Cart

No products in the cart.

AWWA C116 2009

$75.83

AWWA C116-09: Protective Fusion-Bonded Epoxy Coatings For The Interior And Exterior Surfaces Of Ductile-Iron And Gray- Iron Fittings For Water Supply Service

Published By Publication Date Number of Pages
AWWA 2009 21
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This standard describes protective fusion-bonded epoxy coatings for the interior and exterior surfaces of ductile-iron and gray-iron fittings used for water, wastewater, and reclaimed water systems. The standard describes the material, application, and performance requirements for these coatings. This standard does not describe coatings agreed on between the purchaser and the manufacturer for special service conditions, such as saltwater, sewers, acid, high temperature, and so forth.

PDF Catalog

PDF Pages PDF Title
1 Erratum to
ANSI/AWWA C116/A21.16-09
2 ANSI/AWWA C116/A21.16-09
4 Committee Personnel
8 Contents
10 Foreword
I.
Introduction.
12 II. Special Issues.
III. Use of This Standard.
13 IV. Major Revisions.
V. Comments.
14 AWWA Standard Protective Fusion-Bonded Epoxy
Coatings for the Interior and
Exterior Surfaces of Ductile-Iron
and Gray-Iron Fittings

Section 1:
General
Sec. 1.1 Scope

Sec. 1.2 Purpose
15 Sec. 1.3 Application

Section 2:
References
Section 3:
Definitions
16 Section 4:
Requirements
Sec. 4.1
Materials
Sec. 4.2
Surface Preparation
Sec. 4.3
Coating Application
17 Sec. 4.4
Coating System Qualification
Section 5:
Verification
Sec. 5.1
Qualification Testing
18 Sec. 5.2
Production Testing
Sec. 5.3
Holiday Testing
Sec. 5.4
Inspection by Purchaser
19 Sec. 5.5
Basis for Rejection
Section 6:
Delivery
Sec. 6.1
Marking
Sec. 6.2
Shipping, Handling, and Storage Precautions
Sec. 6.3
Affidavit or Certificate of Compliance
AWWA C116 2009
$75.83