{"id":146648,"date":"2024-10-19T08:36:03","date_gmt":"2024-10-19T08:36:03","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/ne-omaha-amendment-2\/"},"modified":"2024-10-25T00:52:38","modified_gmt":"2024-10-25T00:52:38","slug":"ne-omaha-amendment-2","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/ne\/ne-omaha-amendment-2\/","title":{"rendered":"NE Omaha Amendment 2"},"content":{"rendered":"

None<\/p>\n

PDF Catalog<\/h4>\n\n\n\n\n\n\n\n\n\n\n\n\n\n\n\n\n\n
PDF Pages<\/th>\nPDF Title<\/th>\n<\/tr>\n
1<\/td>\nPage 12
Page 24
Page 46
Page 48
Page 49 <\/td>\n<\/tr>\n
2<\/td>\nPage 49
Figure R307.1, Minimum Fixture Clearances. Delete Figure R307.1 Minimum Fixture Clearances, in its entirety.
Page 53
Section R311.4.3, Landings at doors. Change exception 1 to read: 1. Where a stairway of two three or fewer risers is located on the exterior side of a door, other than the required exit door, a landing is not required for the exterior side of the door provided the door, other than an exterior storm or screen door does not swing over the stairway.
Page 53
Page 53
Page 54
Page 54
Section, R311.5.3.1, Riser height. Add an exception to this section to read as follows:
Exception: The maximum riser height shall be 8 inches (203 mm) for a period of one year from the adoption date of this code.
Section R311.5.3.2, Tread depth. Add an exception to this section to read as follows:
Exception: The minimum tread depth shall be 9 inches (228 mm) for a period of one year from the adoption date of this code. <\/td>\n<\/tr>\n
3<\/td>\nPage 54
Section R311.5.3.3, Profile. Change to read as follows: The radius of curvature at the leading edge of the tread shall be no greater than 9\/16 inch (14 mm). A nosing not less than \u00be inch (19 mm) but not more than 1 \u00bc inch (32 mm) shall be provided on stairways with solid risers. The greatest nosing projection shall not exceed the smallest nosing projection by more than 3\/8\u201d (9.5 mm) between two stories, including the nosing at the level of floors and landings. Beveling of nosing shall not exceed \u00bd inch (12.7 mm). Risers shall be vertical or sloped from the underside of the leading edge of the tread above at an angle not more than 30 degrees (0.51 rad) from the vertical. Open risers are permitted, provided that the opening between treads does not permit the passage of a 4-inch diameter (102 mm)
6 \u00bd inch diameter (165 mm) sphere.
Page 58
Page 60
Section R318.1, Moisture control. Add an exception #4 to read as follows: Exception 4. Exterior bathroom walls.
Page 60
Section R319.1, Location required. Change location #2 to read as follows: All wood framing members that rest on concrete or masonry exterior foundation walls and are less than 8 inches (203 mm) from the exposed ground. All wood framing members, sills or plates that rest on concrete or masonry exterior walls.
Page 60
Section R319.1.1, Field treatment. Delete this section in its entirety. <\/td>\n<\/tr>\n
4<\/td>\nPage 61
Page 61
Section R320.1.2, Field treatment. Delete this section in its entirety.
Page 63
Section R324.2.1, Elevation requirements. Change requirement 1 to read as follows: 1. Buildings and structures shall have the lowest floors elevated to or a level 1 foot minimum above the design flood elevation.
Page 63
Page 68
Page 69 <\/td>\n<\/tr>\n
5<\/td>\nPage 71
Page 73
Page 74
Page 76 <\/td>\n<\/tr>\n
6<\/td>\nPage 77
Page 78
Page 79
Page 80
Page 81
Page 82
Page 83 <\/td>\n<\/tr>\n
7<\/td>\nPage 84
Page 85 <\/td>\n<\/tr>\n
8<\/td>\nPage 103
Page 121
Page 132
Table R702.3.5, Minimum Thickness and Application of Gypsum Board. Change footnote (d) to read as follows. D. Three-eighths-inch-thick single-ply gypsum board shall not be used on a ceiling where a water-based textured finish is to be applied, or where it will be required to support insulation above a ceiling. On ceiling applications to receive a water-based texture material, either hand or spray applied, the gypsum board shall be applied perpendicular to framing. When applying a water-based texture material, the minimum gypsum board thickness shall be \u00bd inch. increased from 3\/8 inch to \u00bd inch. for 16-inch on center framing, and from \u00bd inch to 5\/8 inch for 24-inch on center framing or \u00bd inch sag-resistant gypsum ceiling board shall be used.
Page 241 <\/td>\n<\/tr>\n
9<\/td>\nPage 268
Page 289
Page 291
Page 292 <\/td>\n<\/tr>\n
10<\/td>\nPage 299
Page 299
Page 310
Page 311 <\/td>\n<\/tr>\n
13<\/td>\nPage 323
Page 325
Page 329
Page 331
Page 335 <\/td>\n<\/tr>\n
14<\/td>\nPage 347
Page 351 <\/td>\n<\/tr>\n
15<\/td>\nPage 353
Page 354 <\/td>\n<\/tr>\n
16<\/td>\nPage 355
Page 357
Page 359 <\/td>\n<\/tr>\n
17<\/td>\nPage361 <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":"

NE – Omaha – Amendment<\/b><\/p>\n\n\n\n\n
Published By<\/td>\nPublication Date<\/td>\nNumber of Pages<\/td>\n<\/tr>\n
NE<\/b><\/a><\/td>\nN\/A<\/td>\n17<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n","protected":false},"featured_media":146650,"template":"","meta":{"rank_math_lock_modified_date":false,"ep_exclude_from_search":false},"product_cat":[2790],"product_tag":[],"class_list":{"0":"post-146648","1":"product","2":"type-product","3":"status-publish","4":"has-post-thumbnail","6":"product_cat-ne","8":"first","9":"instock","10":"sold-individually","11":"shipping-taxable","12":"purchasable","13":"product-type-simple"},"_links":{"self":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product\/146648","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/types\/product"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media\/146650"}],"wp:attachment":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media?parent=146648"}],"wp:term":[{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_cat?post=146648"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_tag?post=146648"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}