IEC 60717:2012 applies to capacitors and resistors with unidirectional wire terminations intended for use in electronic equipment. This standard provides a method for determination of the space required by capacitors and resistors with unidirectional wire terminations. NOTE: Instead of measuring the actual space, it may be sufficient to ensure that a component fits into the maximum space for which it is designed. This may be achieved by means of fixed gauges. The main technical changes with respect to the first edition are the following: – employment of the millimetre-based grid, the preferred grid system given in IEC 60097, – employment of SI units only, causing deletion of the imperial dimensions from Table 1, – reduction of the tolerance on the chamfer depth in Figure 1, and – introduction of requirements on information to be given in a relevant specification.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 6<\/td>\n | English CONTENTS <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | 1 Scope 2 Normative references 3 Gauge board <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 4 Width and length Figures Figure 1 \u2013 Chamfer of the gauge board holes Table 1 \u2013 Grid hole diameters for the gauge board <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | 5 Height Figure 2 \u2013 Dimensions of a component with two unidirectional wire terminations Figure 3 \u2013 Dimensions of a component with more than two unidirectional wire terminations <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | 6 Information to be given in the relevant specification Figure 4 \u2013 Examples for the height of component with unidirectional wire terminations <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | Annex A (informative) Cross-reference Table A.1 \u2013 Cross-references <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Method for the determination of the space required by capacitors and resistors with unidirectional terminations<\/b><\/p>\n |